Configuring and Launching Benefits Sneak Peek
Click here for click-by-click instructions with screenshots of each step or read on for the key points...
The Benefits Sneak Peek (BSP) video is a 90 second configurable marketing video geared towards Open Enrollment to help boost ALEX engagement. You can include 2-5 key pieces of info you want employees to know ahead of going through enrollment. The video can link out to ALEX (or your benefits enrollment site) to help increase ALEX utilization.
Navigate to Enable Products/Modules and make sure the Benefits Sneak Peek is toggled on.
You'll find it's tabs under Product Settings along the Builder configuration menu– General, Enrollment, and Information Points.
Under the General tab you can add a company logo, and add a hyperlink for the video page to link to.
We always recommend using the main ALEX URL here (or the customer's enrollment/benefits website) as that will help boost engagement.
Using the ALEX URL allows employees to jump straight to ALEX from the Sneak Peek and then they can jump straight to their enrollment/benefits website from ALEX.Under the Enrollment tab you can add in the Open Enrollment dates.
The Information Points tab is where you can add 2-5 headlines/bylines employees should know heading into open enrollment.
Information Points are used to spark interest about the group's benefits and upcoming enrollment (ex: new benefits, important dates, changes to benefit offerings, reminders, etc.)
If you need help getting those creative writing juices flowing, check out our Common Information Points doc attached below!Once all three BSP tabs have been filled in you can launch the video by heading to URLs/Publish.
Click Benefits Sneak Peek to reveal the Launch button.
Click the yellow "Launch" button. The BSP link will arrive in your email within just a few minutes.
Unlike Benefits Counselor/ALEX Go, the Sneak Peek does not have a Preview button. This is because the Sneak Peek is included in your ALEX package at no additional cost.
If you need to make any changes to the Sneak Peek after your initial launch, make those edits in Builder and then Relaunch. You can Relaunch the BSP as many times as needed.